|
R1 front take2
|
30-11-12, 06:46 PM
Would a solution be to cut a thread into extender and fork leg and then screw the two together? There must be sufficient thickness in the leg as the fork caps are held in by a thread inside the leg. Then the top and bottom clamps would hold them in place so no twisting?
Just an idea 
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
R1 front take2 - by tommyteeman - 29-11-12, 04:42 PM
Re: R1 front take2 - by sadlonelygit - 29-11-12, 06:20 PM
Re: R1 front take2 - by tommyteeman - 29-11-12, 06:53 PM
Re: R1 front take2 - by devilsyam - 29-11-12, 07:16 PM
Re: R1 front take2 - by ogri48 - 29-11-12, 07:25 PM
Re: R1 front take2 - by flyboy - 29-11-12, 08:46 PM
Re: R1 front take2 - by devilsyam - 29-11-12, 09:23 PM
Re: R1 front take2 - by flyboy - 29-11-12, 11:36 PM
Re: R1 front take2 - by Falcon 269 - 30-11-12, 08:01 AM
Re: R1 front take2 - by devilsyam - 30-11-12, 08:52 AM
Re: R1 front take2 - by tommyteeman - 30-11-12, 11:55 AM
Re: R1 front take2 - by Falcon 269 - 30-11-12, 05:14 PM
Re: R1 front take2 - by dazza - 30-11-12, 05:36 PM
Re: R1 front take2 - by jackojet - 30-11-12, 06:46 PM
Re: R1 front take2 - by Falcon 269 - 30-11-12, 06:53 PM
Re: R1 front take2 - by tommyteeman - 30-11-12, 07:14 PM
Re: R1 front take2 - by Kosmic Kartman - 30-11-12, 10:27 PM
Re: R1 front take2 - by devilsyam - 30-11-12, 10:54 PM
Re: R1 front take2 - by Falcon 269 - 30-11-12, 11:25 PM
Re: R1 front take2 - by tommyteeman - 30-11-12, 11:44 PM
Re: R1 front take2 - by Falcon 269 - 01-12-12, 08:02 AM
Re: R1 front take2 - by bludclot - 01-12-12, 03:15 PM
|
