16-11-12, 08:30 PM
bought of e bay last week for 160 posted new/old stock with a few tiny display marks(none on the show side), fitted for fifteen minutes before i decided i didnt like it as its too small and modern looking and i wanted more of an old school look like my older "same size as stock"stainless micron set up. runs perfectly on standard jetting due to link pipe bore reduced from 65 to 50 i think. i also shortened the link pipe by fifteen mil where it goes into the can as it didnt sit far enough forward into the strap for my liking.good quality stainless mikalor clips supplied but could have been a bit smaller (supplied were55-59 and63-68 but 52-55 and 60-63 would have been better) so put a few more slots in spigot behind clamp to get a seal. has a removable DB killer for mots, but you wouldnt use it, its not loud without just a nice low burble. v. cheap set up for somebody here before it goes on fleabay £90 collected, £100 posted. tried to show marks in photos but they are minimal