08-11-12, 09:27 AM
Im not sure if its the same kind of setup as the tdm900 in that when the wax melts it allows a small pin to move and reduces the fast running. On them its common for the pin to sieze in the housing so stops moving back out to the cold position so no choke or sticks in cold position and choke wont go off.
Pretty easy to fix on the tdm since it was easy enough to get to. Worth checking to see if its the same fault on your gen 2. Strip the end off clean up the pin and stick it back together. Hope this is of some help.
Cheers Allan
Pretty easy to fix on the tdm since it was easy enough to get to. Worth checking to see if its the same fault on your gen 2. Strip the end off clean up the pin and stick it back together. Hope this is of some help.
Cheers Allan