Hi all I'm in need of some help, I've changed the starter
relay, starter and button to no good as to why it's not
Starting without abump start ?
any ideas what it could be?
Bit more info needed, does it turn over using the button, is the battery okay, etc
More people are born because of alcohol than will ever die from it.
hi when button is pushed there's nothing (no clicking etc)
Battery is fully charged.
Try starting with the clutch in
Check the position of the red cut out switch on the right hand handle bar
Just tried all above and still nothing
Time to check for bad connections to the starter motor. Use a multimeter and see if you are getting power whilst thumbing the starter button
Have you checked all the fuses.
Biking is about the Journey NOT the Destination...
All fuses checked and are ok.all wires feel fine.
Just thinking could it be the immobiliser playing up but starts with bump through.
Cheers
is there a fuse just for the starting ? apart from on the relay
Just a update just been out to it and it started first time
Lmao hahaha
Just flapping about on this stagnant little pond on the outer rim of the internet.....yup.... :-))
As always, it can be a broken wire or corroded connector, a careful visual check of the bundle in the plastic box under the tank and by the battery compartment may show the problem. Otherwise it could be the starter cut-out relay.
Cheers bud will look at it and see what's going on
Looks clean but got one on order now 15 quid
Hope that solves it.
I would have poked around with a multimeter to check it's faulty before splashing out... but I am a skinflint. :lol