After reassembling my micron exhaust, i noticed where the link pipe meets the headers there is a small amount of blowout.
Alot of people seem to try and get an airtight seal in these areas.
Does it make much difference to anything? My bike will backfire a little bit off the throttle from highish revs, is this a possible factor or not?
Ideally it should be a good seal but i don't think it's a major.
My bike used to pop on deceleration, but it went away when i got the carbs balanced.
More people are born because of alcohol than will ever die from it.
could fail mot if tester spots it....if origanal steel pipes get them welded before it gets any worse
One, is never going to be enough.....
Had that problem with my fazer a few years ago, i just bought some heat resistant sealant smothered it on then joined together and left to cure for 2 days,problem solved.
Mine was really bad so had no choice.
mine does that too kinda like the popping noise.
never bothers me with the leaking bit.[size=78%] [/size]
Learning every day.
Isn't the popping noise due to a bit of fuel vapour that isn't burnt off when chopping the throttle at high revs combusting in the exhaust? Can't see it being anything to do with a small exhaust leak...
My old fazer had a slight leak on the front pipes , It used to pop and bang on overun
sounded ok I thought at the time
i have a micron Exhaust and also have a small amount of leakage....
this is usually normal and is the condensation from when you first start up the bike.
ive never failed a MOT or had any problems with it....
ALSO, the popping noise is awesome, especially if you're going under a bridge or through a tunnel! :lol
Ride It Like You've Stole It
More people are born because of alcohol than will ever die from it.
My fazer 600 & zrx 1200 both pop and fart on the overrun.
Zrx is the loudest but sounds great,its all part of the aftermarket replacements.
If it bothers you get jetted.