Hi to all new to this site so might f... up with this post. Has anybody upgraded their suspension with Maxton front or rear , or any recommendations or advice for me and my FZS1000 05 , just purchased , its my second one. I sold the first one 3 yrs ago and regretted it :evil , thanks Paul.
Paul Pickering
I fitted a Hyperpro spring over Christmas and I am very happy with it so far. not only is it firmer than the original it seems to ride much better. I guess like anything it depends on your budget.
I am tempted to get the fork springs to match the rear.
http://www.ebay.co.uk/itm/Hyperpro-Progr...2ec457141d
Good luck and enjoy.
Lord,
Grant me the WD-40 to move those things that are stuck, the Duck tape to fasten those things that are loose, And the wisdom to know the difference.
Amen
Been on to both Maxton and a suspension supplier and KAIS in the North West [Atherton] both seemed to know there stuff , Maxton being the Most expensive at £330 for revalve , springs and set up for front with a possible 100 to replace cartridges as well total £430 for front, respring rear shock with stiffer spring to suit £100 or replace approx £590 with their own tailor made with ride height adjuster / preload.Total £1100 ish!
KAIS quoted £291 for re-valve and set up for front no mention of wear in cartridges ? and £391 for a hyperpro rear shock again built to order but with no remote ride height adjuster/ preload told if you solo you dont really need to constantly adjust , makes sense. They also could remove the original spring which is too soft unless you weigh 8 stone wet through with a stiffer one for about the same £100 .
Any thoughts ? I had an Ohlins on last FZS1000 looked mint but they are nearly a grand for the rear !
Paul Pickering
I've just fitted a Nitron NTR Sport, £360 fitted. Due to chronic weather conditions up here in I've not had the chance to fully test it properly yet.
Best of Luck , hope it works out.
Toured Scotland 2006 , real roads , stunning views great people , must go again. Skye was stunning.
Paul Pickering