|
pilot jets
|
06-07-23, 04:31 PM
hi guys
best way to clean them and how small is the hole that goes through them,bit of wire brush be small enough cheers 
07-07-23, 03:22 PM
I recently did this with mine. I used carb cleaner, a compressor to blow air through the jet, and a bit of wire from a brass wire brush. The jets are made from brass, so any stronger metals (e.g. steel) might damage the them.
07-07-23, 04:56 PM
thank for the response
have tried all that,soaked in carb cleaner over nite.must be really badly blocked can you see daylight through yours when clean think i might have to renew mine.been in there 20 years regards
07-07-23, 05:06 PM
Unless they're visibly damaged, or corroded you should be fine. You can just about see daylight through them when they're clear. A bit of brass wire should do the trick.
gave up trying to clear them,must be really badly corroded inside
got some genuine jets,from a company called motocarb will fit and hopefully the problem is sorted cheers for the help Mikuni Pilot & Air Jets - Motocarb link for there site 
20-07-23, 11:40 AM
(07-07-23, 04:56 PM)fatboy link Wrote: thank for the response Remember that one of the three in each carb is actually a blank and is blocked.
Another ex-Fazer rider that is a foccer again
|
|
« Next Oldest | Next Newest »
|
