Rear shock

[nsr500v4]

Can anyone accurately measure the width of the top of the standard shock so i can get washers made of before fitting the BMW S1000 shock please?

[bludclot]

34.92mm to 35.02mm depending upon which angle i measure across the faces of the bush. it's probably worn unevenly in use.

[nsr500v4]

Cheers Bludclot, i will get the new washers made up now 

[unfazed]

I made up two washers 2.65 mm thick 12mm hole in centre

[bludclot]

i am in need of 2 appropriate washers, any chance one of you can make up / obtain a pair for me please? funds can change hands in return obviously.

[mickvp]

i should be able to make up a couple of sets in work next week if you dont mind waiting bludclot? I wont charge you anything, wont cost me much to pop a pair in an envelope.

Anyone got any idea what the od of the washer should be roughly? just dont want them to have too-big a diameter obviously, and im too lazy to strip out my shock to measure it :lol

[red98]

I'll be taking my shock off tomorrow evening.i'll post the sizes then...anything else while ive got it off ?

[mickvp]

12mm ID, 2.65mm width, just need OD red

unless of course you guys want a fancy design or surface finish :lol

[red98]

Ok...will post tomorrow 

[red98]

Shocks off.do you want the od of the washer on the top mount ?

[red98]

or the metal sleeve that passes through the top of the shock....

[unfazed]

25mm OD will be fine

[mickvp]

aye. anywhere between 23-25mm will be ok then

Cheers Red, your a star mate.

[red98]

No probs for me, needed to replace the swingarm bearings so your timing was spot on.......this is why the forum is so good.....everyone helping one another....