Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Remove old glue from tank
#1
Hi guys,


My Yamaha tank pads are peeling off so I bought a generic pad set from Amazon to replace it. Underneath the old pads is loads of glue. Does anyone know if there's a way of removing this without damaging the paint work on the tank?


Thanks,


David.
[Image: 239627.png]
Reply
#2
solvent based tar and glue remover.

one of the best on the market is Autosmart TARDIS, but there are other ones you can get in halfords etc.


make sure to clean off the T&G remover properly though Smile
Reply
#3
baby wipes
"Life should NOT be a journey to the grave with the intention of arriving safely in an attractive and well preserved body, but rather to skid in sideways - Chardonnay in one hand - strawberries in the other - body thoroughly used up, totally worn out, and screaming - WOO HOO! What a Ride!"
Reply
#4
Dont bother getting anything "fancy" as you already have what you need cause its in your tank------- petrol
I don't do rain or threat there of. dry rider only with no shame.
Reply
#5
(10-01-14, 05:56 PM)fazersharp link Wrote: Dont bother getting anything "fancy" as you already have what you need cause its in your tank------- petrol


I did this to get the old rubbish tank pad, and those annoying "read owners manual first" labels off too. Just don't douse it or rub at it for too long. I used an old credit card to kind of scrape the mushy glue off too as it's plastic and didn't scratch the paintwork.




Simon
Reply
#6
when its at that tacky stage keep pushing and rolling it with your thumb and then pick off the sticky balls !!!!!
I don't do rain or threat there of. dry rider only with no shame.
Reply
#7
Wd40 will help shift it, or use a hairdryer on a hot setting to help with scraping and rolling

Reply
#8
Thanks for the suggestions. Weather permitting, I'll give them a go tomorrow morning.
[Image: 239627.png]
Reply
#9
Done this a few times, hairdryer to get the glue warm, use your thumb to roll it up into small balls then WD40 or petrol to get the last few bits off.
Reply


Forum Jump:


Users browsing this thread: