Advice please!

[Dave48]

On removing bellypan on my FZS 1000 I discovered radial cracks in the plastic surrounding the rear mounting holes. :'(  Front ones have rubber inserts with steel bush so these ok. Rear ones have no anti-vibration bushes/collars-is this correct? Any recommendations re "plastic welding/repair?

[CRH]

i had similar problem with the fairing on my fjr ...the btm rear mounts on that were doing exactly the same!!! what i did was trap the bolt between 2 rubber tap washers !! just have to enlarge holes a bit?? job done!!

[chris.biker]

The hugger on my bike had the rear mounting hole wear a way, I repaired it by Evo Sticking a patch of plastic on the inside out of sight. It has held, if this is any help.