Mirrors with built in indicators

[Gray fox]

Has anyone tried fitting mirrors with built in indicators to a Gen 1? I have seen these on a few modern bikes & think they look good. This of course would leave some nasty looking holes in the fairing, which is one more problem to overcome. I'm running out of mods to do now & need another project. So if anyone knows of any mirrors that fit i would be grateful for the info.

[tex]

 
 I got some from busters, They work ok,£25 down from £50. they are a generic type so will fit most bikes, screws in the brake side, and you can get a bracket of ebay for the clutch side, or get a fz8 clutch bracket with the threads built in, it is a perfect fit. It does leave two holes , but you can get some block off plates, not sure where, im sure somebody will be along with a link .
 
               Tex

[phil on a fazer]

 I got some from busters,
 
               Tex

photos!!!

I always thought i would like to have tiny indicators in the side of my mirrors but i would also keep my normal winkers (like cars) but also have some small DRL's in the back of the mirrors too. All helps you be seen.

[Phil TK]

 Don't forget the offside mirror needs a Yamaha left hand thread (it does up anti-clockwise). If the mirrors you want do not come in a left hand thread version you can buy an adapter quite cheaply.

[bigralphie]

I have got some for my tuono but not wired them up yet to cold lol ,you may need to fit resistors eg http://cpc.farnell.com/welwyn/wh25-6r8-ji/resistor-25w-5-6r8/dp/RE04134?Ntt=RE04134 or your bike might think the leds are a blown bulb and the flash rate will go mad

[ZiggyCol]

On my old FZS600 I 'made' some mirrors including indicators.
 
I used the original mirrors and cut holes in the back to accomodate some side indicator repeaters from a car. The old 600 mirrors were good for this because the rubber gaitor ran all the way up the mirror stem which allowed you to conceal the wires running from the fairing indicators.
 
The end result was actually quite good.