Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
LED Rear light
#1
Have any of you 600 Foccors upgraded their rear light to an LED one? If so, do you need to put an inline relay on so you dont blow the LED's?

Ta very muchio  Big Grin
I am the Nightrider. I'm a fuel injected suicide machine. I am the rocker, I am the roller, I am the out-of-controller!
Reply
#2
Not something I've done myself, but the 12V dual circuit LEDs are a direct replacement for the 5/21W filament lamps. No relays required.
Reply
#3
Cheers for that Fazerider!! Much appreciated!!  :lol
I am the Nightrider. I'm a fuel injected suicide machine. I am the rocker, I am the roller, I am the out-of-controller!
Reply
#4
Hi, just got one of these for a birthday pressie. Dead easy, just remove your original light and plug the new one in. Looks really cool! :eek
shakes aint that bad!
Reply
#5
(31-01-12, 08:00 PM)cherokee link Wrote: Hi, just got one of these for a birthday pressie. Dead easy, just remove your original light and plug the new one in. Looks really cool! :eek

sweet!! think i will order me one of them then!!  :lol
I am the Nightrider. I'm a fuel injected suicide machine. I am the rocker, I am the roller, I am the out-of-controller!
Reply
#6
(31-01-12, 08:00 PM)cherokee link Wrote: Hi, just got one of these for a birthday pressie. Dead easy, just remove your original light and plug the new one in. Looks really cool! :eek
:useless
Reply
#7
Have had one on mine for ages.It was a direct swap for the original, looks much better and it's a lot brighter.
Reply
#8
(01-02-12, 07:19 PM)topgun44 link Wrote: [quote author=cherokee link=topic=1539.msg11590#msg11590 date=1328036420]
Hi, just got one of these for a birthday pressie. Dead easy, just remove your original light and plug the new one in. Looks really cool! :eek
:useless
[/quote]




Attached Files
.jpg   Rear lense.jpg (Size: 91.71 KB / Downloads: 46)
I am the Nightrider. I'm a fuel injected suicide machine. I am the rocker, I am the roller, I am the out-of-controller!
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)