Great Save

[cbx63]

Makes a change from all the wrecks

Lucky Save by Yamaha FZ1

[ChristoT]

A good save indeed!

The only question is how come he lost it in the first place? I couldn't see any fault that he made, and road surface was good!

[dBfazer600]

It looks like he rolls off the throtle then back on just before the rear goes, but yes great save.

Daz

[ddtwelve]

two things i noticed his peg touches the floor lifting back wheel and the rear tyre afterwards looks soft??

[Lawrence]

That corner seems to catch out a lot of people.

[Buzz]

The rider left a comment on the vid:


"I dropped to 1st. When I came out of the corner and went back on the gas my torque was high and she started to slide"


Also said he was in a crossed up position as he was going for max lean angle...whoops.

[Exupnut]

That corner seems to catch out a lot of people.

I agree. Loads of videos on utube with bikes comin off that corner but why? It seems a bit of a hotspot for vid makers fotographers and bikers alike. People have hit the rails othher bikes/pushbikes there. Was that vid of the biker takin out 2 cyclists here aswell? Badd juju or bad skills?

[ChristoT]

It's a known nasty, a sharp hairpin. I think people do push a bit hard around it, and get caught out.

And yes, same corner as the cyclist crash too.

[Skippernick]

The rider left a comment on the vid:


"I dropped to 1st. When I came out of the corner and went back on the gas my torque was high and she started to slide"


Also said he was in a crossed up position as he was going for max lean angle...whoops.

[Skippernick]

The rider left a comment on the vid:


"I dropped to 1st. When I came out of the corner and went back on the gas my torque was high and she started to slide"


Also said he was in a crossed up position as he was going for max lean angle...whoops.

So he changed gear mid-corner!!! Enough said really.

[redthunder]

All I see from watching that vid is him coming off the throttle some about 2-3 secs before the back starts to slide. Don't see a gear change... but when he gives it more throttle it fixes itself

[Dead Eye]

[quote author=Buzz link=topic=7702.msg74875#msg74875 date=1368092924]
The rider left a comment on the vid:


"I dropped to 1st. When I came out of the corner and went back on the gas my torque was high and she started to slide"


Also said he was in a crossed up position as he was going for max lean angle...whoops.

So he changed gear mid-corner!!! Enough said really.
[/quote]

I think he means he was in first gear for the corner and ended up with too much torque when exiting - possibly tried to give it a bit too much power a bit too early. Not sure that first is the best gear to be in since I usually find its not exactly the smoothest of gears - tbh though his bike his probably set up significantly better than mine

[ddtwelve]

def no gear change mid corner the bike seems to die when he comes off the throttle just before the slide but no foot moemnt or clutch movement

[Skippernick]

oh ok i assumed he meant he changed gear half way round the corner.