FZ1 Centre stand bracket

[Dunky]

Lets try this in here.

Anybody any comments on this ? should there be a bracket bolted here for holding the right hand side of the centre stand see clouded area in picture if so has anybody got one laying around or have the dimensions so I can fabricate one up.

Cheers Dunky.............

[neely71]

nicely highlighted mate wish i new the black art of squiggly lines on the putter

[stevierst]

Sorry bud, ill take a picture of mine tomorrow when I show it the light of day.

[Dunky]

nicely highlighted mate wish i new the black art of squiggly lines on the putter

Neely open the picture in paint put the squiggly lines on and save the picture when you close the program.

[Dunky]

Sorry bud, ill take a picture of mine tomorrow when I show it the light of day.

Stevie thanks for the reply and a close up picture would be most appreciated as would any dimensions but I'm sure I will get this problem sorted out.
Thanks again mate.

Dunky.............

[stevierst]

Here's a few shots of the centre stand bracket from various angles.

Sent from my HTC One X using Tapatalk 2

[stevierst]

From underneath, at the exhaust end.

Sent from my HTC One X using Tapatalk 2

[stevierst]

On the centre stand.

Sent from my HTC One X using Tapatalk 2

[stevierst]

The measurements from what I can gather are:- 55mm between the two shiny silver bolts,
35mm from the left shiny bolt to the stand pivot bolt.
67mm from the front shiny bolt to the centre stand bolt.
These measurements are from each bolt centre.
15mm radius on each curve from the centre of the adjacent bolt hole.
Plate thickness is 4-5 mm.

If you need any more, just ask and ill get my ruler out.

Sent from my HTC One X using Tapatalk 2

[Dunky]

The measurements from what I can gather are:- 55mm between the two shiny silver bolts,
35mm from the left shiny bolt to the stand pivot bolt.
67mm from the front shiny bolt to the centre stand bolt.
These measurements are from each bolt centre.
15mm radius on each curve from the centre of the adjacent bolt hole.
Plate thickness is 4-5 mm.

If you need any more, just ask and ill get my ruler out.

Sent from my HTC One X using Tapatalk 2

Stevie thanks for the pics and the dimensions these are very much appreciated now I have an idea of what I need to fabricate to make one up.
Once again mate thanks for your info .

Dunky.............