paddock stand crash bobbins anyone seen owt like these

[fazerkev]

these are off a r1 so wont fit , i have removed centre stand and want something like this for my fzs1000 03 plate as i dont like the stands that just fit under the swingarm they mark it and move about a bit , anyone seen owt like this for the fazer

[ghostbiker]

Are those the spindle fit ones? I did see a crash bung set of spindle rods that doubled up as bobbins on the rear. Just can't remember where i seen them.
Been thinking about modifying my spindle crash bungs. It's basically a thread bar and 2 bungs so should be possible to find a way to swap the bungs to bobbins.
Or the ones you linked I could even place on the inside of my bungs.

[fazerkev]

yes they fit in place of the spindle ajusting blocks ,

[snapper]

I think giles do a set for the fazer

[Pat]

Don't really see the point as you need the spindle in place for them to work, so you'll still need another stand eg. Abba or refit the centrestand to take out the rear wheel.

However, As the rear spindle is hollow, if you just need to get the wheel off the floor, why not just get a length of steel bar that'll slot through it leaving a few inches sticking out each side for the paddock stand hooks to engage on?

[bludclot]

it's fairly straight forward to get a local machine shop to make up some threaded ally mounts and either weld or have them welded to the underside of the swing arm...