Hello foc'ers, can anyone identify this. Looks to me like some sort of bearing spacer.....10mm inside dia, 15mm outside and 4mm thick. Found it near my bike :eek
|
Should I be worried
|
15-08-12, 06:50 PM
Oh F*ck mate that's the Farkle gland! And yes,you should be worried. :eek
15-08-12, 07:07 PM
Have you done your exup recently ? it looks like the shaft spacer fron that !
15-08-12, 08:32 PM
Well done lads, yep done it last week. Looks like I'll be having it out again tomorrow. Been walking past it for 3 days now, thought it was a rubber washer until I booted it (like ya do). :lol
15-08-12, 08:51 PM
I was worried, about a year ago, as the master wasn't coming near me for many months, I decided to Ivanise my bike with a s/o kit. All went well, except that I lost a needle spring from one of the carbs. (A very small spring like half a cigarette lighter spring.) I cleared my bench off, and cleared and swept half the garage out with no luck. A replacement cost me about £35 and had to include a needle kit. I finished the job, and found the original spring about four weeks ago trodden into the coconut mat in front of my bench, undamaged!
15-08-12, 08:59 PM
(15-08-12, 06:50 PM)Rusty link Wrote: Oh F*ck mate that's the Farkle gland! And yes,you should be worried. :eek dont listen to rusty hes winding you up................thats the flange washer that holds the gangle pin in place 
One, is never going to be enough.....
|
|
« Next Oldest | Next Newest »
|
Users browsing this thread: 1 Guest(s)