|
LINK PIPE
|
28-11-11, 04:51 PM
I've decided to revert back to standard can but the bore is too big to fit onto recently installed SS downpipes. Can I use heat resistant tape to wrap around the pipe at the back end of the downpipes so that the link pipe from the can fits properly? If not what can I use to create a decent seal between the two ends? Thanks.
28-11-11, 04:57 PM
Daft question but, you havn't just lost the gasket have you? 45mm ID - 50mm OD.
Save the planet...It's the only one with beer!
28-11-11, 05:24 PM
Lol. Yeah looks like I have. Never crossed my mind.
|
|
« Next Oldest | Next Newest »
|
