I received both packages — the R1 collector and the motor with the cables. The collector didn’t fit because of the two side pipes (wrong bend). I had to take mine apart, cut the welds, and drill out all three broken bolts. But everything went together in the end. I adjusted the cables. Finally, the bike doesn’t rumble under the windows in the morning 
It rides a bit better now, but not quite what I was hoping for. I’ll be ordering Ivan’s kit in the winter. Thanks everyone.
![[Image: GmFz9F8tmL7Y3TkwVjuGXZ4rhMkxNxq1hvn0ThTk...bb5h47.jpg]](https://www.upload.ee/thumb/18589668/GmFz9F8tmL7Y3TkwVjuGXZ4rhMkxNxq1hvn0ThTk68JVt0MA_N9bc7Lv5xlp3W9UzVW547kY_0Ej42xlNEbb5h47.jpg)
I don’t really understand the logic of how this EXUP works. When you turn on the ignition – nothing happens. When you start the engine, it lifts up a little. If you rev it, it moves. But when you switch off the engine, it doesn’t always go all the way down. After shutting it off, you need to turn the ignition on and off again, and only then the valve flag returns to the zero position.
It rides a bit better now, but not quite what I was hoping for. I’ll be ordering Ivan’s kit in the winter. Thanks everyone.![[Image: GmFz9F8tmL7Y3TkwVjuGXZ4rhMkxNxq1hvn0ThTk...bb5h47.jpg]](https://www.upload.ee/image/18589668/GmFz9F8tmL7Y3TkwVjuGXZ4rhMkxNxq1hvn0ThTk68JVt0MA_N9bc7Lv5xlp3W9UzVW547kY_0Ej42xlNEbb5h47.jpg)
I don’t really understand the logic of how this EXUP works. When you turn on the ignition – nothing happens. When you start the engine, it lifts up a little. If you rev it, it moves. But when you switch off the engine, it doesn’t always go all the way down. After shutting it off, you need to turn the ignition on and off again, and only then the valve flag returns to the zero position.