28-03-25, 08:10 PM
(28-03-25, 07:21 PM)darrsi Wrote: I vaguely remember when I put my new clutch plates on that there was a problem when I tightened everything up, but the cause was due to the clutch adjuster screw sticking out from its previous position with the worn plates.
I had to undo the clutch cable locking nut, back off the middle adjusting screw, then tighten things up again from the other side, then it all worked nicely again once the clutch adjustment nut was adjusted to the new plates position.
Hope that makes sense?
I've done this to no avail unfortunately, backed the push rod side of the adjuster off completely and readjusted to quarter turn before tight (with clutch adjuster flush as loose as possible) and no dice. Cable just feels like i'm pulling against itself i.e. stretching it