28-03-25, 06:15 PM
(28-03-25, 06:05 PM)BBROWN1664 Wrote: putting the bike in gear, possibly with a piece of wood through the wheel, would stop the engine trning to allow you to torque these up normally.
As for running the engine and gettign 0 wheel spin when you put it in gear, sounds like the clutch isnt engaging at all now
You may need to readjust the clutch using the bolt on the gear lever side and then the cable again.
Yeah thats what im thinking, however the pressure plate felt like it was spinning individually of the inner basket - I suspected i lost the ball bearing and have replaced this so i'll give it a revisit this weekend, im just hesistant to whip off the cover for need of a new gasket etc.