Fz1: question - 3rd party handlebars

[unfazed]

They are as follows:

• Standard 7/8inch diameter.
  
• End to end bare handle bars without the bar ends in place 650mm 25.5 inches
  
• Center to center of the mount on the top yolk is 85mm about  3 and 5/16inches
  
• The sweep back from the centre line is about 400mm 4inches
  
• The rise is about 65mm 2.5inches
  
• They will only take the FZS600/Fzs400 end weights 
  

• Same as my FZ1, its pretty much standard on most motorcycles.
  
• The FZ1 ia 650/660mm, so good match.
  
• I dont understand the context of this info.
  
• This seem like a lot, on the FZ1, the sweep is 80mm.
  
• This also seems like a lot, but if accurate is unfortunatly this is way too much. At most I only need half that.
  
• Hmm these do look like they have less weight to them - https://www.fowlersparts.co.uk/parts/418...ndle-cable
  

Wrote it down incorrectly have read 100mmm 4 inches I corrected it