09-08-24, 12:55 PM
Hi everybody.
I’m new to this site and new to Fazer ownership. I’ve looked at all the threads on this subject and just wanted to check my summary is correct:
I’ve measured my nut
(
) and believe it’s 9mm so I should get a new one…?
The washer tabs should be bent over (I don’t think they are now)?
The shaft thread diameter should measure 17.76 but can get away with 17.5mm?
The consensus seems to be to use locktite 270…? This needs to be heated to remove??
The torque for the new nut is 90nm?
Any suggestions for who currently does the cheapest good quality nut? £12.99 on eBay with the washer…
Ta.
I’m new to this site and new to Fazer ownership. I’ve looked at all the threads on this subject and just wanted to check my summary is correct:
I’ve measured my nut
(
The washer tabs should be bent over (I don’t think they are now)?
The shaft thread diameter should measure 17.76 but can get away with 17.5mm?
The consensus seems to be to use locktite 270…? This needs to be heated to remove??
The torque for the new nut is 90nm?
Any suggestions for who currently does the cheapest good quality nut? £12.99 on eBay with the washer…
Ta.