08-01-24, 03:13 PM
(07-01-24, 07:28 PM)b1k3rdude link Wrote: @Gnasher will correct me if Im wrong, but think they go over those pipes and then through a guide loop bolted to the righthand side of the steering column and then info the handlebar assembly.
Sounds about right to me. Make sure you go under the frame cross member, which is above and forward of the where the cables joins to the carb linkages. Over the top of the engine and over the front rad hose, up through guide loop, up through the back of the fork yokes, around the right fork tube and up to the handle bar and throttle housing.
Once connected and adjusted, start the bike and with the engine at idle, turn the bars fully left and right. If the revs rise/fall the cable is either incorrectly routed/adjusted or both. There should be no change is rpm and you should have full throttle movement/return at full lock both sides.
Later