30-11-22, 07:38 PM
So reading on Pats site about how to set TPS position it goes on to say at the end of a method recommended by Ivan.
This involves moving the TPS in relation to rpm. This is supposed to give a good position to reduce vibes.
Ivans/Pats write up goes on to say by using this setup method on putting the TPS into test mode it can show 10k rpm and not 5k rpm, which is the recommended position.
Can someone explain to me what the significance is of the 5k and 10k settings are and why it dosent seem to matter, infact the write up suggests its better at 10k?
Cheers
This involves moving the TPS in relation to rpm. This is supposed to give a good position to reduce vibes.
Ivans/Pats write up goes on to say by using this setup method on putting the TPS into test mode it can show 10k rpm and not 5k rpm, which is the recommended position.
Can someone explain to me what the significance is of the 5k and 10k settings are and why it dosent seem to matter, infact the write up suggests its better at 10k?
Cheers