12-11-22, 08:12 PM
(12-11-22, 05:25 PM)agricola link Wrote: Replaced them with Yam OEM from Fowlers. I always tend to use OE for what I consider critical parts, never had any problems with them (apart from cost, but its only every 25k so justifiable)
When I did the 4 degree ignition advancer mod, I bought a pattern gasket which I think was about a third of the price on an OEM one.
There again, if you really want to save money, you can buy gasket sheet and cut out the required shape from that (not tried this myself, yet...)
Quote:The one I forgot to order at the same time was the small copper washer on the cooling system drain plug, which resulted in a drive up to CMC at Clay Cross to obtain
When I upgraded the fork springs to Hyperpro, I bought a box full of assorted sized copper crush washers which was about the same price as buying three Yamaha ones!