08-11-22, 09:37 AM
Morning ladies and gentlemen, and thank you for the warm welcome to this helpful place.
I’m Sam,
Bought a 2000 FZS 600 with 6k miles that has been stood for 9 years (£560) so seemed a bargain. Was sold as a none runner but luckily found it to the the older Datatool alarm system so I bypassed it and she fired up after a whiff in the air box. Now I know she will start (fingers crossed)Carbs are off (that was fun ?? and cleaned) I’ve renewed all filters,plugs,fuel,etc and now looking at the engine as it has flaking paint to the top end block ((bottom like new)
Can these be sprayed in situs? I will take the lump out if needs but was hoping not to, also the fork seals are in good condition but the dust covers definitely not… any advise as I’ve ordered done covers and hoping it’s an east job lol
I’m Sam,
Bought a 2000 FZS 600 with 6k miles that has been stood for 9 years (£560) so seemed a bargain. Was sold as a none runner but luckily found it to the the older Datatool alarm system so I bypassed it and she fired up after a whiff in the air box. Now I know she will start (fingers crossed)Carbs are off (that was fun ?? and cleaned) I’ve renewed all filters,plugs,fuel,etc and now looking at the engine as it has flaking paint to the top end block ((bottom like new)
Can these be sprayed in situs? I will take the lump out if needs but was hoping not to, also the fork seals are in good condition but the dust covers definitely not… any advise as I’ve ordered done covers and hoping it’s an east job lol