Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
THROTTLE OFF, REVS GOING DOWN SLOWLY. BUT THROTTLE NOT STICKING
#4
Well im no further forward with problem :rolleyes .  Circlip on carb 3 wasnt too tight, gave it about a quarter turn. Apart from that couldnt find any air leak . So decided to put carb tune on and see what that showed.  To be honest they werent too bad. Carb 1 was about the most out but not by much.
So tried another wee run and just the same, shut throttle and it runs on.
Now ive been doing a but of thinking and yep i may have small air leak somewhere, but is this possible,,,
when lining up timing marks when putting head together which were right just before final tightening and torque ,,, have i just knocked it off slightly.
The reason im now thinking this is im sure i read someone putting head back on and when tightening down cams the two small end dot you line up moved off slightly,,, but i cant find the post to see his problem.
Im sure i didnt move the alternator off its mark,, but now begining to question it. 
If ive knocked timing off would it cause bike to not throttle down properly.  Any ideas.
Oh on short run i did open throttle a bit, and just as i thought it didnt want to pull , i wasnt expecting it too but just opened to see what would happen.
Reply


Messages In This Thread
Re: THROTTLE OFF, REVS GOING DOWN SLOWLY. BUT THROTTLE NOT STICKING - by TOM VR46 - 07-05-22, 10:20 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)