03-05-22, 01:41 AM
Soz , its a bit late but ive been doing a lot of head scratching :z .
Ive just spent 3 days putting a new cam chain in,, around 75000 on old one so new one needed. No adjustment left on tensioner. :'(
All seemed ok. Running in shed ,, didnt rev to much in shed as i wanted all engine parts to settle and oil to flow round.
Then off for wee run.
Out of drive and i noticed shutting off throttle and the revs were'nt dropping too quick. Not sticking open , just coming down slowly. :rolleyes
Just a short run and still the same at the end.
But i never touched the carbs,,, just took them off,,, and put them back on. Yep cables were off but when i put them on i checked the throttle and it was'nt sticking just usual nice spring back when you let go. And again after run ,, throttle just snaps back but revs come down slow.
any ideas, cause i confuzzed :o
Ive just spent 3 days putting a new cam chain in,, around 75000 on old one so new one needed. No adjustment left on tensioner. :'(
All seemed ok. Running in shed ,, didnt rev to much in shed as i wanted all engine parts to settle and oil to flow round.
Then off for wee run.
Out of drive and i noticed shutting off throttle and the revs were'nt dropping too quick. Not sticking open , just coming down slowly. :rolleyes
Just a short run and still the same at the end.
But i never touched the carbs,,, just took them off,,, and put them back on. Yep cables were off but when i put them on i checked the throttle and it was'nt sticking just usual nice spring back when you let go. And again after run ,, throttle just snaps back but revs come down slow.
any ideas, cause i confuzzed :o