19-10-21, 11:48 PM 
		
	
	
		Removed the regulator / rectifier mounting bracket to clean it up and repaint.  Installed a helicoil type repair to the radiator side cover mounting hole which had been stripped out previously.
Also removed the R/H footpeg to sort out the wear in the clevis pin bores that was causing the peg to hang below level. Used a Durafix rod to braze up the peg ears that bear on the mounting clevis and then filed them back to shape. Peg now hangs level and straight.
	
	
	
	
	
Also removed the R/H footpeg to sort out the wear in the clevis pin bores that was causing the peg to hang below level. Used a Durafix rod to braze up the peg ears that bear on the mounting clevis and then filed them back to shape. Peg now hangs level and straight.

 
 

 
