03 1000 cut out and wont start

[FazThou]

I'm assuming the alarm was poorly fitted then if you have removed it so easily?  Part of the correct hard wire is that it's cut into the loom, just by removing it without restoring all the original circuits and depending on how it was wired some or all of the ignitor, coil, pick up coil, starter relay, kill switch, ignition power circuits will be cut.         

I assume this alarm was fitted correctly as it was connected well into the loom and into oe connectors

The loom is fully opened, so you cut open the binding on the loom to remove the alarm, now the bike starts?

No sorry badly worded, the loom is completely opened and i can temporarily connect wires to various places to get it to start, but would like to get the replacement relay and not have it "hot wired"  :lol