17-05-21, 10:11 PM
Hi Unfazed - yep all present and correct.
I think the issue is elsewhere though - The overall extended length of the fork appears to be too long.
The bits inside add up as follows:
185 damper
316 spring
200 spacer
1 washer
10 cap
----
712mm
The extended length of the stanchion and damper is 760 - so a 48mm gap in the top of the stanchion though it didnt look that much.
Im not worried about the gap inside - that will disapear when I find the real issue.
With the stanchion fitted into the tube and the damper rod bolted in, extending the whole leg to max extension (with seals and clips all in place) the leg is too long. The gap between the dust cap and bottom yoke is greater than on other fzs that people have measured and when the brakes are fitted, the pipes ae like bow strings. No slack at all.
I think the issue is elsewhere though - The overall extended length of the fork appears to be too long.
The bits inside add up as follows:
185 damper
316 spring
200 spacer
1 washer
10 cap
----
712mm
The extended length of the stanchion and damper is 760 - so a 48mm gap in the top of the stanchion though it didnt look that much.
Im not worried about the gap inside - that will disapear when I find the real issue.
With the stanchion fitted into the tube and the damper rod bolted in, extending the whole leg to max extension (with seals and clips all in place) the leg is too long. The gap between the dust cap and bottom yoke is greater than on other fzs that people have measured and when the brakes are fitted, the pipes ae like bow strings. No slack at all.
Another ex-Fazer rider that is a foccer again