07-12-20, 10:36 AM
Simple. 
Turn the screws in fully until they just seat, then back them out 4 & 1/4 turns.
Haynes manual would only give stock settings anyway, so not relevant for the Full Monty install.
Ivan himself says 4 & 1/2 to 5 turns out but I found that made the idle mixture a bit too rich.
Turn the screws in fully until they just seat, then back them out 4 & 1/4 turns.
Haynes manual would only give stock settings anyway, so not relevant for the Full Monty install.
Ivan himself says 4 & 1/2 to 5 turns out but I found that made the idle mixture a bit too rich.