18-10-20, 07:17 AM
(17-10-20, 06:18 PM)cojonesdeloro link Wrote: Almost listed it on the bay today but had a look at the TPC after watching a YT vid, I can set it to 5000rpm but soon as I crank it over and check again its back to 10k, dies this tell us anything lads? P.S float bowls are full and I smell fuel at the pipe, plugs are wet just didnt look obviouse as they are still shiney. ?
The thing about the TPS is that from experience they don't tend to just stop working, they break down over a period of time so that you don't even know it's happening until the bike starts running really roughly.
You said you cleaned your carbs, but only now have you found the TPS, but to set the carbs up properly you most certainly need the TPS to be functioning correctly as well.
The fact yours quickly goes to 10,000rpm means it's malfunctioning but not fully dead as it would otherwise go to 3000rpm, so i'm surprised you can't get it to at least start for a second or two, but either way it will certainly affect starting and will run rough at low revs or when ticking over, even more so if the carbs are not set up in any way.
Are the fuel mixture screws all turned out equally and correctly as well, as you've not really mentioned that?
Do not buy a used TPS
https://www.ebay.co.uk/itm/Yamaha-FZS-60...SwVJ9fa1Hg
More people are born because of alcohol than will ever die from it.