I have set lines from rear tyre edges along to the front and have set up a bar in a vice to hold it and set the front lines at 160 which is the rear tyre widith. form here I can measure the offset.I adjust everything as you should, top yoke measured equal side to side. With top yoke pinch bolt tight, centre yoke nut lose and bottom home pinch bolt loose, I have bounced the forks several times to try and centralize the front end. I am doing this job on the main stand and not a rear paddock stand but I can't see it interfering with things.
The back end has be adjusted and checked with a caliper and is spot on.
I'll have a go at it again this afternoon.
The back end has be adjusted and checked with a caliper and is spot on.
I'll have a go at it again this afternoon.