03-07-20, 06:17 PM
If your side stand switch has been playing up before start there, test the switch by pushing the switch in the live should be cut on the return, if not loop the switch out e.g. disconnect it and loop the connection, does it start?
Then the same with the clutch, does it start?
The neutral switch the same only it's a little plunger, located literally at the back of the gear box casing, it's the only electrical connection in that area.
If all the above are fine, check the battery, anything less the 12.6 it's needs a charge, once charged and you've started the bike check the voltage across the battery with the engine running, if less than 13, rev it if you get no increase, there's a problem with the charging system. If you get 13 and an increase in voltage, charging is fine, battery is likely issues. If the problem happens again it's a naff battery not holding charge.
Then the same with the clutch, does it start?
The neutral switch the same only it's a little plunger, located literally at the back of the gear box casing, it's the only electrical connection in that area.
If all the above are fine, check the battery, anything less the 12.6 it's needs a charge, once charged and you've started the bike check the voltage across the battery with the engine running, if less than 13, rev it if you get no increase, there's a problem with the charging system. If you get 13 and an increase in voltage, charging is fine, battery is likely issues. If the problem happens again it's a naff battery not holding charge.
Later