(I've posted this on the Facebook forum too)
I was trying to balance my throttle bodies today on my FZ6-SA 2006.
I hooked all the gauges to cylinger 1 to calibrate them and worked out the differences in readings. no problems.
But when I came to actually trying to balance them, I did have a problem.
Here's the set up...
I'd checked the idle speed, tweaked the adjusters on the adapters so the needles on the gauges were just not jittering, blipped the throttle a couple of times then let them settle, but no matter what I tried and how much I altered the throttle screws, for some reason I simply could not get much movement on the gauges and certainly not enough to get the readings even nearly the same
I don't know what I'm doing wrong. Anyone got any helpful suggestions?
I was trying to balance my throttle bodies today on my FZ6-SA 2006.
I hooked all the gauges to cylinger 1 to calibrate them and worked out the differences in readings. no problems.
But when I came to actually trying to balance them, I did have a problem.
Here's the set up...
I'd checked the idle speed, tweaked the adjusters on the adapters so the needles on the gauges were just not jittering, blipped the throttle a couple of times then let them settle, but no matter what I tried and how much I altered the throttle screws, for some reason I simply could not get much movement on the gauges and certainly not enough to get the readings even nearly the same
I don't know what I'm doing wrong. Anyone got any helpful suggestions?