New owner rotor question

[albuquerqueturkey]

Was a ballache to refit as the teeth on the gears were a pain to line up then I had to coax it in with a hammer. After all that I took the gasket out and it turned out to be the wrong one, my fault I didn't check when I ordered so just sorted one out now and should be here by Thurs/Fri.

After watching many videos the best trick was to turn the crank with the back wheel in gear to get it to line up, took a few attempts but it worked.


The Athena gasket i got is rubbish, id get a genuine one if i have the cover off again.