27-04-20, 09:31 PM
I had the same issue couple weeks ago on my FZS600. Snapped only one though. Snapped flush with the head, I tried drilling but there is limited access and by drill bit wend a bit sideways. Luckily I've not caused too much damage
Since it was in the middle of the head I just decided to bolt everything together with new gaskets to see if it'd seal. I had to jam a nut between one bracket and the pipe so it doesn't rattle. It sealed fine.
It is a botch job but it works.
I can't see your photo but, depending where they broke, if all else fails and you don't want paying loads of money to have them drilled out maybe it's worth a try?
Since it was in the middle of the head I just decided to bolt everything together with new gaskets to see if it'd seal. I had to jam a nut between one bracket and the pipe so it doesn't rattle. It sealed fine.
It is a botch job but it works.
I can't see your photo but, depending where they broke, if all else fails and you don't want paying loads of money to have them drilled out maybe it's worth a try?