10-01-20, 09:58 AM
(09-01-20, 09:07 PM)nivek24 link Wrote:Hi, when you removed the bottom part did you notice what the difference in length between the new and old, i was thinking the new one would be shorter, if so could the old one be machined on a lathe to make it smaller in length.
kev
No, I never checked the difference in the length as I had to cut the old one off anyway. I suppose you could shorten the existing one, if you can get it off without damage, four jaw chuck and face off the threaded end. Then youll have to drill and tap out the thread to maintain the correct depth