01-12-19, 11:48 PM
Bike refused to start today .
The Meta alarm had gone completely dead .
I decided the only way to cure this once and for all was to remove the Alarm.
After striping of the rear bodywork (the alarm unit is under the tail unit) I cut out the motion senor ,indicator,side light ,led,earth and live wires .
This left just the ignition circuit that had been cut into.
One I found this I cut and re solderd the wires back together..
The bike then started.
The Meta alarm had gone completely dead .
I decided the only way to cure this once and for all was to remove the Alarm.
After striping of the rear bodywork (the alarm unit is under the tail unit) I cut out the motion senor ,indicator,side light ,led,earth and live wires .
This left just the ignition circuit that had been cut into.
One I found this I cut and re solderd the wires back together..
The bike then started.
Over Land and Sea