CLUNK,CLUNK,CLUNK,CLUNK

[TOM VR46]

It was the same as unfazed. But, as in unfazed pic , the flare pin , you can see clearly the point that would enter the pin on link to be flared.
The set I got  , if you had taken pic at same angle as in unfazed pic , you would not have seen as much of the point. When I held it up to the link to be flared , the point was in the hollow and flush with the face, this to me  would not have done any flaring.
So, after a bit of head scratching and looking through old tools I found a small punch , similar to tool one in the picture. A little bit of work and it looked ok. The point was same size as the hollow in link , but has more of an angle to flare.
The thing I got wrong was just the pressure, because you are flaring to such a small degree,  it would have been ok if I had not gone for the last wee tweek on it. My fault  :\
But the tool in unfazed pic looks a lot better than the one I got.