07-10-19, 10:34 AM
(This post was last modified: 07-10-19, 01:40 PM by fazersharp.)
(07-10-19, 02:09 AM)TOM VR46 link Wrote: Sorry the pic isn't the best. Ive got just a basic flaring tool of ebay. But the flare part of the set didn't seem to good so I made a part which gave a little bit more of a spread to the pin. The part that came with the set seemed as if it would have been apply direct pressure without any flare. I do have a Vernier but the display is working properly so I cant say how much im flaring the pin but it wasn't a lot. If I had have stopped and not gone that little bit more it looked ok. But I do have a habit of just a wee touch more, and this is the usual result. Not as bad as when I was younger but is still snap things every now and again. But ill know the next time, which will probably be next weekend.What was the tool.
I used this one youtube.com/watch?v=skX2GhrB2Oc
STUPID VID WONT LINK, copy and paste this youtube.com/watch?v=skX2GhrB2Oc and add the www.Its by Afam Although I did think afterwards that the pin that does the pressing into the hole looked a little worn after I had done the two link pins. Not sure if it would do such the same good job if used again.
I don't do rain or threat there of. dry rider only with no shame.