05-10-19, 03:21 PM
Just refurbed carbs..new mixture screws in a couple o rings etc, and now resetting the mixture screws to 2 1/2 turns (003 model)..after setting to 2 1/2
turns, carb number 1 has no part of the screw showing in the mouth of the carb but 2,3,and 4(tps side carb)have about 1mm sticking through
Should they all be protruding above the rim of the mouth of each carb, or is it normal that carb 1 screw is flush with the mouth of the carb ?
cheers
clive
turns, carb number 1 has no part of the screw showing in the mouth of the carb but 2,3,and 4(tps side carb)have about 1mm sticking through
Should they all be protruding above the rim of the mouth of each carb, or is it normal that carb 1 screw is flush with the mouth of the carb ?
cheers
clive