Bike has been laid up for a while. I had the carb's ultrasonic cleaned because the throttle valves were stuck in the closed position . They had previously been full monty Ivanised by Mike and all was well up until I had to stop riding the bike. Now has 7k error code which is obviously the EXUP faulty after a period of non-running. I will sort this out but...….
Bike started up fine but settled to a very fast idle, well over 2000rpm and fiddling with the idle adjuster does nothing. Is this likely to be due to the EXUP before I check the throttle cables and, if needed, tear the carb's back off - which I'm loathe to do yet again? Could the fast idle be due to incorrect float heights when reassembled by the ultrasonic guys at Ragged Moto?
when in doubt go flat out