14-07-19, 01:01 AM
I presently have a functioning clutch sprocket but the push rod is in two pieces.
Ordered a new push rod, and oil seal as well because the break is about 75mm from the sprocket side.
So seal may have been damaged when the rod snapped.
also to get the rest of rod out. I am looking for a small magnet stick on end of one piece and magnetically remove the remaining length from inside or remove old seal and use long nose pliers to get the 2nd part of the rod out....
ordered clutch gasket at same time in case need to take off clutch cover and remove rod from that side....
friends got a low torque wrench for the clutch spring bolts if I need it.
Ordered a new push rod, and oil seal as well because the break is about 75mm from the sprocket side.
So seal may have been damaged when the rod snapped.
also to get the rest of rod out. I am looking for a small magnet stick on end of one piece and magnetically remove the remaining length from inside or remove old seal and use long nose pliers to get the 2nd part of the rod out....
ordered clutch gasket at same time in case need to take off clutch cover and remove rod from that side....
friends got a low torque wrench for the clutch spring bolts if I need it.