Hi all,
I'm sure this has been asked before and at the risk of repeating a previous post here goes:
I'm about to start a project, first thing to do is to swap my clock (1st gen FZ1) for an 5JJ R1 (00-01) clock.
First:
Does anyone have a pin layout for the connector plug for both machines please, I understand it's only a case of swapping some pins - but which pins?
I understand that after rewiring the pins, everything should display correctly on the replacement speedo (except for the fuel level because the R1 doesn't have a gauge).
Next:
The R1 cluster doesn't have a fuel gauge, but I'd still like to have one, is it possible to fit an aftermarket gauge by connecting it to the fuel level wire from the loom?
Many thanks in advance for your help.
I'm sure this has been asked before and at the risk of repeating a previous post here goes:
I'm about to start a project, first thing to do is to swap my clock (1st gen FZ1) for an 5JJ R1 (00-01) clock.
First:
Does anyone have a pin layout for the connector plug for both machines please, I understand it's only a case of swapping some pins - but which pins?
I understand that after rewiring the pins, everything should display correctly on the replacement speedo (except for the fuel level because the R1 doesn't have a gauge).
Next:
The R1 cluster doesn't have a fuel gauge, but I'd still like to have one, is it possible to fit an aftermarket gauge by connecting it to the fuel level wire from the loom?
Many thanks in advance for your help.
If it aint broke, make it better