27-06-19, 12:31 PM
im sure this just came up last week
i had same problem on a different set of carbs- i went round my local hardware shop and just bought a cheap set of extractors and used the smallest one and put a good amount of pressure on as i turned it anticlockwise, i didnt even predrill it - just put a small phillips in there gave it a smack and then turned it to create a center punch type indent (always drill after a center punch to make sure its centre and dont go too big)
i had same problem on a different set of carbs- i went round my local hardware shop and just bought a cheap set of extractors and used the smallest one and put a good amount of pressure on as i turned it anticlockwise, i didnt even predrill it - just put a small phillips in there gave it a smack and then turned it to create a center punch type indent (always drill after a center punch to make sure its centre and dont go too big)
riding this that and the other
vloggin some bits - https://www.youtube.com/channel/UCvWtJO9...R9RNHx72UQ
https://www.instagram.com/disorderly_punk_yt/
vloggin some bits - https://www.youtube.com/channel/UCvWtJO9...R9RNHx72UQ
https://www.instagram.com/disorderly_punk_yt/