24-06-19, 09:38 PM
(This post was last modified: 25-06-19, 10:57 PM by mobile mouse.)
completed full overhaul to both front calipers and replaced the pads.... back to great front brakes...
started on the rear... Not done for some time. Still got some meat on the pads, one caliper pad pin came out with some persuasion.
But the 2nd was a pig.
lots of Plus gas and then a good alen key and pop the key stripped the hex.
Any ideas how to get it out.
I have been looking at bolt removers and even watched video on Delboy's Garage
https ://www.youtube.com/watch?v=nSxhvYu-x4g
But i don't have a welder... I do have JB Weld Original anyone tried this...
started on the rear... Not done for some time. Still got some meat on the pads, one caliper pad pin came out with some persuasion.
But the 2nd was a pig.
lots of Plus gas and then a good alen key and pop the key stripped the hex.
Any ideas how to get it out.
I have been looking at bolt removers and even watched video on Delboy's Garage
https ://www.youtube.com/watch?v=nSxhvYu-x4g
But i don't have a welder... I do have JB Weld Original anyone tried this...