15-06-19, 06:52 PM
PS I've taken the instruments out and tried using a multimeter to check the connectivity, but I've not had much luck.
According to the wiring diagram in the Haynes manual, the black and white wire going into the cluster is the ground / negative, but I've tried using both the "diode" setting and resistance settings on my multimeter without being able to get a reading...
According to the wiring diagram in the Haynes manual, the black and white wire going into the cluster is the ground / negative, but I've tried using both the "diode" setting and resistance settings on my multimeter without being able to get a reading...