New Chain Time = Sprockets too ?

[fazersharp]

For general bike maintenance I've always used 3/8" drive sockets or 1/4" for anything a bit dainty. Mind you the front sprocket nut will be 1/2" drive on a breaker bar and no doubt a length of tube over the bar to increase leverage. A length of 3x2 timber wrapped in some cloths through the back wheel usually does the trick. I'll be in the garage later and let you know the socket size.

Thanks. I was hoping to be able to use a normal 1/2inch socket ratchet - all-be-it with a bar over it.
So maybe I should invest in a breaker bar. This one worth getting do you think
https://www.screwfix.com/p/hilka-pro-cra...r-24/1186k

Or this.
https://www.machinemart.co.uk/p/pro77-1-...eaker-bar/